Nonlinear response of a parametrically excited buckled beam

A nonlinear analysis of the response of a simply-supported buckled beam to a harmonic axial load is presented. The method of multiple scales is used to determine to second order the amplitude- and phase-modulation equations. Floquet theory is used to analyze the stability of periodic responses. The perturbation results are verified by integrating the governing equation using both digital and analog computers. For small excitation amplitudes, the analytical results are in good agreement with the numerical solutions. The large-amplitude responses are investigated by using a digital computer and are compared with those obtained via an analog-computer simulation. The complicated dynamic behaviors that were found include period-multiplying and period-demultiplying bifurcations, period-three and period-six motions, jump phenomena, and chaos. In some cases, multiple periodic attractors coexist, and a chaotic attractor coexists with a periodic attractor. Phase portraits, spectra of the responses, and a bifurcation set of the many solutions are presented.     

爆炸荷载作用下钢筋混凝土梁的动力响应及破坏形态分析

对基于Timoshenko梁理论建立的非线性动力有限元法作了改进。根据压区理论得到混凝土的平均剪应力和平均剪应变关系,建立了能反映箍筋的抗剪作用的材料模型;此外,对结构在爆炸荷载作用下可能出现的各种响应现象进行了描述,以准确地预测梁破坏时不同位置截面上钢筋和混凝土的受力、变形及破坏情况。应用改进的材料模型,对爆炸荷载作用下的五个钢筋混凝土试验梁的动力响应和破坏形态进行了数值模拟,结果表明,该数值方法能较好地模拟钢筋混凝土梁的弯曲、弯剪和剪切等破坏形态。     

Localized solutions to the nonlinear wave equation for flexural motions of an elastic beam traveling in an air-filled tube

Steady-progressive-wave solutions are sought to the nonlinear wave equation derived previously [J. Fluids Struct. 16 (2002) 597] for flexural motions of an elastic beam traveling in an air-filled tube along its center axis at a subsonic speed. Fluid-structure interactions are taken into account through aerodynamic loading on the lateral surface of the beam subjected to small but finite deflection but end effects and viscous effects are neglected. Linear dispersion characteristics are first examined by exploiting the small ratio of the induced mass to the mass of the beam per unit length. Centered around the traveling speed of the beam, there exists such a narrow range of propagation velocity that the linear steady propagation is prohibited. In this range, it is revealed that some interesting nonlinear solutions exist. The periodic wavetrain is found to exist as the exact solution. Asymptotic analysis is then made by applying the method of multiple scales and the stationary nonlinear Schrödinger equation is derived for a complex amplitude. A monochromatic solution to this equation corresponds to the exact periodic solution. Imposing undisturbed boundary conditions at infinity, it is revealed that the localized solution exists as a result of balance between the linear instability and the nonlinearity. This solution is checked by solving the nonlinear equation numerically. It is further revealed that the amplitude-modulated wavetrain exists not only in the range of the velocity mentioned above but also outside of it.     

变分原理分析开裂简支箱梁剪力滞效应

变分原理通常应用于箱形截面梁剪力滞效应弹性分析,本文基于换算截面法,运用变分原理推导了预应力混凝土简支箱梁均布荷载作用、钢筋混凝土简支箱梁集中荷载作用的剪力滞系数计算公式,考虑了混凝土开裂对箱梁剪力滞效应的影响,并与试验结果和规范方法进行了对比分析。变分原理分析开裂混凝土箱梁剪力滞效应方法力学概念明确,是其弹性分析适用范围的拓展,亦可推广应用到混凝土连续箱梁开裂后的剪力滞效应分析,具有广阔的应用前景。     

阶梯压电层合梁的波动动力学特性

采用行波理论系统地研究了压电阶梯梁的自由振动分析以及强迫响应的分析方法. 基于分布 参数理论研究了压电阶梯梁的波传播特性，忽略柔性梁横向剪切和转动惯量的影响，给出了 梁的轴向和横向的简谐波解. 将压电阶梯梁离散化为单元，考虑压电片的刚度和质量的影响， 建立了节点散射模型. 应用位移连续和力平衡条件，推导了节点的波反射和波传递矩阵，在 此基础上，引入波循环矩阵的概念，给出波循环矩阵、波传递系数矩阵的确定方法. 应用波 循环矩阵可以有效地计算结构的固有频率. 另外，应用波传递系数研究了压电陶瓷作动器位 置对其驱动能力的影响. 得出两个主要结论：1)作动器靠近悬臂梁固定端将有较强的驱动 能力，悬臂梁边界反射行波产生弯曲消失波有利于增大压电波的模态传递系数；2)模态传 递系数与固有频率的灵敏度密切相关，波传递系数越大, 对应该处固有频率变化灵敏度越大. 另外，数值算例表明了行波方法比有限元方法具有更高的计算精度.     

SMA纤维复合材料梁振动半主动控制

分析了一类形状记忆合金(SMA)纤维混杂层合粱用于振动控制的动力学模型和作用机理．采用多胞模型、形状记忆合金一维本构关系分析方法，同时考虑横向剪切的影响，建立了层合梁的数学模型．半主动控制是通过改变受控结构的参数来减小结构振动的响应．根据开关控制原理确定可变刚度系统的控制律，进行SMA纤维混杂层合粱的半主动控制的数值仿真．结果表明，将半主动控制应用于梁的振动控制是一种有效的方法．     

受电子束辐照的硬铝靶的喷射冲量耦合系数随能通量的变化规律

采用通光式传感法和直接测量特定时间间隔的探头原理，在闪光２号装置上进行了电子束辐照硬铝靶产生的喷射冲量耦合系数与能通量关系的研究。结果表明:在能通量为１１５～２４０Ｊ／ｃｍ２范围内，喷射冲量和亏损质量面密度都随能通量近似线性变化，而喷射冲量耦合系数随能通量增大而缓慢递增，并趋于一渐近值；硬铝产生喷射冲量的能通量阈值为４０Ｊ／ｃｍ２左右；喷射冲量值为８１～２１８Ｐａｓ，亏损质量面密度为３．１ １０－２～８．６１０－２ｇ／ｃｍ２，喷射冲量耦合系数为０．７０～０．９８Ｐａｓ／（Ｊ／ｃｍ　２）。     

汽车碰撞砼护拦过程的数值模拟

将汽车与砼护拦简化为刚体，给出了描述碰撞过程中车辆三维空间运动的Ｅｕｌｅｒ－Ｌａｇｒａｎｇｅ方程－微分代数方程组，采用半显式外插方法求解上述方程组。数值计算得出的车辆各方向上的最大平均加速度、最大侧倾角、最大俯仰角、车轮沿护拦面的最大爬升值及车辆脱离护拦时的弹出角等结果是从乘员风险和车辆轨迹等多角全面评估砼护拦的安全性能的重要依据。针对美国ＮｅｗＪｅｒｃｙ型砼护拦的实际算例与文献结果吻合较好。     

玻璃纤维增强聚氨酯泡沫塑料的压缩力学性能研究

本文研究了两种不同密度的玻璃纤维增强聚氨酯泡沫塑料在准静态压缩下的力学性能。给出了与相应密度的普通泡沫塑料力学性能的比较，实验结果表明：两种增强泡沫塑料在压缩载荷作用下，具有不同于普通泡沫塑料的应力－应变特性，压缩模量和强度一般均有不同程度的提高，而且对相同纤维含量的增强泡沫塑料来说，密度较高的材料增强效果较好。     

混凝土层裂强度测量的新方法

提出了利用Hopkionson压杆测量混凝土层裂强度的新实验方法:用高聚物材料取代传统的金属材料透射杆,混凝土试件为细长杆,由于高聚物波阻抗比混凝土小,试件中压缩波在试件/吸收杆界面反射后形成拉伸波使试件产生层裂破坏,通过吸收杆上透射波形可以确定混凝土层裂强度。由于波在粘弹性材料中的弥散效应,吸收杆中透射波形会发生变化,但三维有限元分析表明,在利用吸收杆上透射波确定混凝土层裂强度时弥散产生的影响可以忽略。按照一维特征线理论,可以由吸收杆上的应变波形确定出混凝土材料的层裂强度。